Page 1 of 1
Front Bump stop Position
Posted: Sun Jan 25, 2015 5:37 pm
by convertibled
During my rebuild i have repaired my front inner wings so although the rectangular holes clear the damper arms I am not sure where to fit the lower bump stop brackets. Any dimension will do but maybe a vertical dimension from the front damper pivot to the rubber or any of the bumper stop bracket fixing holes would help.
Re: Front Bump stop Position
Posted: Sun Jan 25, 2015 6:15 pm
by philthehill
Here you go and as requested[frame]
[/frame]
All measurements taken outside and under the wing.
If you want to measure from the bottom of the inner side of the inner wing subtract the inner wing to engine tray flange, which on my Minor is 15mm.
Re: Front Bump stop Position
Posted: Sun Jan 25, 2015 9:20 pm
by convertibled
Perfect!
Thanks very much.
Carl