Page 1 of 1

speedo voltage regulator

Posted: Fri Jul 25, 2014 1:34 pm
by moggiethouable
I fitted a temperature gauge a while ago and wired it to the spade connector at the back of the speedometer.
It has recently decided to go off scale, am I right in suspecting the little voltage reg behind the speedo?
It aint the engine which even in these hot climes is as cool as a cucumber.
Which begs the question of course......."why bother"? :roll:

Re: speedo voltage regulator

Posted: Fri Jul 25, 2014 1:40 pm
by samuria
i had the same thing with mine :roll:
changed the voltage reg. and all was ok :D

Re: speedo voltage regulator

Posted: Fri Jul 25, 2014 2:22 pm
by biomed32uk
The fuel gauge will also be reading high if the voltage reg has given up, presuming you know where it was before,

If not then its a problem from the gauge to the sender, not earthed out anywhere ?.

Re: speedo voltage regulator

Posted: Fri Jul 25, 2014 4:40 pm
by bmcecosse
Earthing out is the most likely explanation. Is it still off-scale when you unplug from the sensor? If not - then the sensor has failed -or just maybe the end has become coated with enough 'rust' to form an earth path. remove and clean! If still off scale - look for a short on the connecting wire.