Morris Minor Owners Club

Hi all i,m new here and have the proble
m of no spark any where points etc i have replaced points c ndensor,distributer cap
leads and now i,m waiting. on a new coil to arrive.i took the engine out 5mths ago to take the head of etc and put the engine
back in it turns over ok and all the leads are in the correct places i also put on a new earth strap the points are set etc
the coil seems to get hot after a while and theres very little spark from one of the connectors on the coil.This is really annoying
me.any ideas or any of yous chaps had this problem??Really want to get my moggy on the road.Please help.

Hi and welcome to the forum. How familiar are you with fitting points? A common problem is fitting the two wires and the plastic washers in the wrong position/order. (Sorry to offend you if you are an expert)
If the coil gets hot then it sounds like you have a permanent earth at the points. Do you get a slight spark at the points when you open them manually?
Where are you, perhaps someone local could help out.

It's NEVER the coil! And the fact it's getting hot means it is passing current - and it's fine!! Edit -as Beero describes above... There must be a short to earth 'downstream' of the coil. Are you SURE it's connected correctly? White wire to coil, and then white/black wire from coil other terminal to dizzy? Take the wire off the dizzy - is there 12 volts there? If so - then the fault to earth is in the dizzy........

Hi i ain,t no expert on points etc as its all new to m e i set them using a feeler gauge and connected them the way the old set
where.i,m trying to upload a photo of my coil,dissy etc.

Hopefully someone near you will be able to pop round and sort it out for you.

If the new coil don,t work then i,ll have to get someone in to look at it.its prob easy fix but only easy if you know what your looking for lol.

Try this:
Key off.
Remove distributor cap.
Put small piece of clean paper between points.
Disconnect wire at distributor that comes from the coil.
Turn key on.
Touch the wire from coil to the distributor terminal.
If you get a spark. it tells us that the problem is probably as Beero said, "A common problem is fitting the two wires and the plastic washers in the wrong position/order."

HTH

Thanks for the input folks.i,ll maybe get time in a couple of days to try a few of these ideas out.thanks any more input more than welcome.

The important thing with the points is that the 2 wires and their connectors must be touching the spring that goes to the moving contact but must NOT touch the post or the nut and it is the position of the plastic washers that achieve this. Try a search on google as there must be a diagram out there somewhere.
Here is a picture to help[frame][/frame]

Thanks beero i,ll double check them.its good to see a photo like this.i,ll get back on this.

That's a great & crystal clear explanation Beero !

ITS ALIVE....got a chance this afternoon checked the points and as correctly pointed out to me by bmceccose i didn,t have the wire touching the spring on the points.but beero posted the clear diagram and i worked of that and it started.Still learning everday lol.
so a big thanks to everyone for there help.

Told you it wasn't the coil ! It NEVER is !!!

Good, so glad you got it going.