Page 1 of 1

pressure in my rocker cover

Posted: Fri Apr 18, 2014 5:57 pm
by Mr Don
My wife's Moggy Humphrey has recently started "misfiring" so I have been methodically servicing the ignition and fuel system.

But today I noticed something I am not sure about. When I removed the oil cap to listen to the engine, tappets, with the engine running, I noticed quite a bit of pressure.

With my hand over the oil filler, it feels a bit like an exhaust pipe. But other than a good bit of mayo/oil and water condensation.

Could my head gasket be going? or something worse valve issue? Or is some pressure in the rocker cover normal and not related to the misfire.

Tomorrow I will replace the points, condensor, rotor and dissy cap.

Is pressure in rocker normal?
:-?

Re: pressure in my rocker cover

Posted: Fri Apr 18, 2014 6:14 pm
by bmcecosse
No! It indicates a worn engine.....but can be mitigated to an extent by making sure the breathing arrangements are clear. Stub pipe on rocker cover clear? Rubber hose to carb clear? Or is it stuck into the air filter casing - coating the filter with oily crap?

Re: pressure in my rocker cover

Posted: Fri Apr 18, 2014 6:34 pm
by MarkyB
Could my head gasket be going?
Absolutely, Do a compression check to be sure if you like.

Re: pressure in my rocker cover

Posted: Fri Apr 18, 2014 7:37 pm
by Mr Don
Thanks guys,
I could do without striping the head this weekend.

Ignition and dizzy, tomorrow to trace the intermittent misfire. Then ensure engine oil breather tubes clear. :)

Re: pressure in my rocker cover

Posted: Fri Apr 18, 2014 11:03 pm
by bmcecosse
Seriously - head gasket has nothing to do with rocker cover pressure........ :roll:

Re: pressure in my rocker cover

Posted: Sat Apr 19, 2014 8:33 am
by kennatt
unlikely,but it could. If the gasket was blown between the cylinder and an oilway hole,but I've not seen it,usually between cylinders