Page 1 of 1
Oil pressure gauge
Posted: Fri Feb 28, 2014 2:13 am
by sansvalo
Hello, I have just started fiddling with the engine. I'm going to order the spin on kit from there
http://www.morrisminorspares.net/shop_item.php?ID=2046 , as well as rocker cover gasket when I finally set the valves.
How can I put the oil gauge on?
http://www.ebay.co.uk/itm/Classic-Mini- ... 19ca6c93cb is this ok? Where can I find a mechanical gauge that fits this? Or does it come in a kit? I'm really worried about the pressure, and my oil pressure wiring is totally rotten. Thank you!
Re: Oil pressure gauge
Posted: Fri Feb 28, 2014 9:57 am
by bmcecosse
That kit will fit a Minor - you just need a gauge now! I wouldn't bother with a 'spin on' kit - but it's up to you. Many modern cars are going back to paper element filters - the Minor led the way...... Here's a proper gauge - avoid the ghastly 'TIM' gauges....
http://www.ebay.co.uk/itm/VERY-NICE-VIN ... 1c3cebf83f
Re: Oil pressure gauge
Posted: Fri Feb 28, 2014 10:20 am
by mike.perry
I can see that you may have problems removing that plug from the head. The plug normally has a hex so that you can remove it with a socket.
I would be extra careful when fitting that sensor, it is very easy to break the capillary tube when tightening it. Been there, seen it, done it
Re: Oil pressure gauge
Posted: Fri Feb 28, 2014 10:45 am
by bmcecosse
I'm wondering if that IS a plug - or is it part of the casting? Don't see any evidence of a seal under the head.... Maybe on engines where no gauge was intended - they eliminated the threaded pocket and hex plug to save a few pennies? Can't see why it would have a 'slot' though - if it's not intended to be removable. Has anyone seen anything like this before?