Morris Minor Owners Club

My speedometer is not working properly it does move but it doesn't show the correct speed and some times gets stuck as it is now showing just wondered it any one knows why it isn't working and if they know how to fix it I thought it might be that it needs oil but want to get more advice before I tackle it as I don't have any experience in doing this thank you.[frame][/frame][frame][/frame][frame][/frame][frame][/frame]

It needs opening up and CLEANING - be very careful with it - and be v sparing with the oil......as you would with a clock.

Thank you how do I find out about how to take it out of the dashboard?

Search Google for a free online workshop manual,,,, But basically - open the glove boxes and you will find two holes - through which you loosen the speedo clamp screws and then slide it out - disconnecting the cable and the bulbs/electricals as you go. Make sure you know which bulb goes where......

This is what you are looking for.
Regards
Declan



Driver's side (RHD)
[frame][/frame]
Passenger side[frame][/frame]

if you PM me your email address I can let you a copy of a pdf manual on stripping / rebuilding the speedo

You don't NEED to take the glovebox liners out (as in the excellent pics above) - you will be able to get a driver on them through the holes provided.

bmcecosse wrote:You don't NEED to take the glovebox liners out (as in the excellent pics above) - you will be able to get a driver on them through the holes provided.

True Roy if they are not repro where the holes don't line up like mine.
Regards
Declan

Thanks for the tips guys going to tackle it tomorrow

Be sure to get 'charlie's guide on the speedo - it's good!

Just got it thanks guys

i have the same problem on girlfriends mog got a new cable for it do i put a bit of oil round where the cable goes into the speedo

NO!!!!

If the speedometer has been out before, it's possible someone has harmed the little brass bushing in the middle of the magnet wheel. If the bushing has been pushed back (that is to say, toward the front of the car when the speedo is mounted), then the needle cup can slide such that it binds on the magnet wheel surface.

Ask me how I know...

Hello. The tourer I have just bought came complete without a speedo cable so I have nothing to show me the route it takes. I have pulled the speedo forward and out ready to put the new cable on which is ok, but I don't know the route it takes down to the gearbox?

Just the most gentle/easy curves you can arrange. I suggest you test the speedo with a reverse running electric drill to make sure it works. If it's seized it will ruin the new cable.......

Thank you for your help. Does it first pass through the bulkhead though? Or down through the floor without entering the engine bay area. I just can't see an obvious passage.

Chris.

Through the bulkhead and down/round to the gearbox.

On further investigation the old cable is still there, so I have the route now.

Thank you again.

bmcecosse wrote:Through the bulkhead and down/round to the gearbox.

Thank you.