Morris Minor Owners Club

Hi there everyone, have had my first problem with my minor - the speedo stopped working! It squeeked for about quarter of a mile while I was going about 40, and then stopped working entirely.

Tested it using a drill and it was completely seized, so I stripped it down as far as I could go to try and fix the problem - turns out it's jammed/stuck between the bit that spins & accepts the drive and the housing (if that makes sense), but I can't strip it down any further to try and fix it, as it's held by 2 rivets that I don't fancy drilling out as I don't know how I could refix it.

The jammed speedo broke the drive cable too

So the question is: has anyone got any experience with this problem and any ideas on how to fix it without drilling the rivets?

Or if not, what speedo could I replace mine with? The serial number is: 4419/04 1376 in a 1965 minor 1000, although I'm thinking this is perhaps not the right one? I'm not particularly concerned with originality, so do I just need to find one with a similar tpm to 1376?

Thanks everyone!

Just grab another speedo -always plenty about - £5 should secure one ! It really should be a 1408 tpm speedo for your final drive - but the difference is tiny, either would do.

Thanks, I'll keep an eye out, and 5 quid?! All I've been able to find is closer to £30...

Remeber he is scottish!

http://www.ebay.co.uk/itm/MORRIS-MINOR- ... 624wt_1152

Thanks for the link Matt, I've already been scouring the auctions, I had seen that one, but as far as I know it wouldn't be suitable - 1280 tpm is a bit low (I think)

hm a fiver if you are lucky

The 1408 is the correct speedo for a 1098/4.22 diff but over reads considerably so you may well find that a 1376 would be more accurate. Test it against a sat nav.

Was that a change that BMC made, to try to correct the wildly optimistic readings?

hi again, would this be a suitable replacement?

http://www.ebay.co.uk/itm/281167896673? ... 1438.l2649

I know it's from a mini, but it is 1408tpm, and I presume the same diameter and so will fit?

You could count actual tpm for your car if you have enough speedo cable left.
Lay out a course of 52 ft. 9.5 inches, that's 1/100 of a mile. count your turns over that course and multiply by 100.

This will help, too.
http://home.comcast.net/~rhodes/speedo.pdf

As long as it is 1408 it will be fine. Very slight difference in the mounting lugs - but easily fitted to a Minor.

David W. wrote:You could count actual tpm for your car if you have enough speedo cable left.
Lay out a course of 52 ft. 9.5 inches, that's 1/100 of a mile. count your turns over that course and multiply by 100.

And thanksfor the link - I've already had a read through - it says at one point that he's never had to drill out the two rivets that I need to!

Cracking idea! Although my speedo cable is well and truly knackerd, but I might have to give this a go!

& bmc, cheers, I might have to buy this one if it goes for cheap!

tudge i have just emailed you a pdf copy of a manual on rebuilding a speed

If any one else would like a copy of this manual please drop me a Pm with your email address.