Page 1 of 1
Horn Switch
Posted: Mon Sep 16, 2013 12:02 pm
by Tapitha
My horn switch/button in centre of steering wheel has taken to falling out. There doesn't seem to be any positive locking device and after trying to refit it I have resorted to blu-tak. What should hold the unit in place? Very inconvenient to have it fall out when going round a corner and having it dangle on its short length of wire!
Cheers,
Mike
Re: Horn Switch
Posted: Mon Sep 16, 2013 12:31 pm
by moggiethouable
Does it need, Has it got, the retaining clip/clips as shown below?
http://morrisminorspares.co.uk/shop/adv ... n&x=7&y=10
Re: Horn Switch
Posted: Wed Sep 18, 2013 3:28 pm
by Tapitha
Thank you for your help. You are right, there is no sign of any clips so I will order some. I had expected that it just pushed in and turned something like a radiator cap.
Cheers,
Mike
Re: Horn Switch
Posted: Sat Jun 21, 2014 5:37 pm
by Tapitha
Following on from my question regarding the horn button on 16th September I have now got round to buying the clips. However I haven't a clue as to how they are fitted. I have looked carefully at the steering wheel centre but can't see how the clips fit. As usual the various workshop manuals don't mention them. It amazes me how what I find difficult is ignored while they go on at length about what is obvious!!
Help needed, please,
Mike
Re: Horn Switch
Posted: Sat Jun 21, 2014 8:47 pm
by LouiseM
The clips just clip over the spare 'gaps' in the back. Hopefully this helps:[frame]
[/frame]
Re: Horn Switch
Posted: Sun Jun 22, 2014 3:12 pm
by Tapitha
Many thanks for the photo showing the clips. I now have an idea of how to fit them.
Mike
Re: Horn Switch
Posted: Fri Jun 27, 2014 2:37 pm
by Tapitha
Clips successfully fitted to horn push and horn still works!
Thank you for the help.
Cheers,
Mike