Page 1 of 1

Carburettor ID required

Posted: Thu Jul 25, 2013 5:07 pm
by gtt1951
My '51 MM has the following Carb (looks similar to the one on my spare 803cc engine, but not quite[frame]Image[/frame]
Other side looks like this[frame]Image[/frame]
It is an SU carb and the ID No.s are 2298 on the Float Chamber and 3457 on the body.
Is this a H1 type? I need to get a gasket set as it leaks!
General view under the bonnet[frame]Image[/frame]

Re: Carburettor ID required

Posted: Thu Jul 25, 2013 8:09 pm
by seriesmm_1
Yes it is an H1 carb,angle is different to 803
BrianR

Re: Carburettor ID required

Posted: Fri Jul 26, 2013 12:13 am
by mike.perry
SU H1 horizontal carb with float chamber at the front, as fitted to later MMs. Overhall kits available from Burlens Fuels

Re: Carburettor ID required

Posted: Fri Jul 26, 2013 8:39 am
by gtt1951
Thanks Mike, I had already found that site, but needed confirmation of what I had - their blown-up diagram of the H1 shows a cover that has its fixing lugs offset from the centre line, so I was a bit unsure.
George.

Re: Carburettor ID required

Posted: Fri Aug 02, 2013 10:13 pm
by sparesman
we have lots of seal kits in the club spares.

Re: Carburettor ID required

Posted: Fri Aug 02, 2013 11:39 pm
by gtt1951
PM sent, George.