Morris Minor Owners Club

Hi,

I was always under the impression that a low biting point meant there was plenty of wear left and the clutch could be adjusted. My biting point is on the floor, so i thought id investigate.

The adjustment screw is fully tightened so there is no thread left visible, so it seems i was wrong. Does anyone know what might be going on?

All the links and the carbon thrust will have worn - put a spacer on the shaft and then you can tighten a bit more which should keep you going for a few more miles - but i would start looking for a replacement without delay......

As above and buy the best one from ap about £125 not the super cheap made on the moon at around £65,better still new old stock ,see my recent experience here


http://www.mmoc.org.uk/viewtopic.php?f=1&t=50757

good luck

Thanks - that should keep me busy ..