Page 1 of 1
Ital 1300 spigot bearing
Posted: Sat Jul 06, 2013 1:08 pm
by southerly95
Putting in an Ital 1300 with 6 hole flywheel, it was previously used in a Traveller with standard gearbox and clutch. Spigot bearing is badly worn and have found that standard 1098 version is too loose a fit. Will the spigot needle roller bearing that ESM and bull motif sell fit? Thanks, John
Re: Ital 1300 spigot bearing
Posted: Sat Jul 06, 2013 1:10 pm
by bmcecosse
It should do - it is a needle roller bearing in that crankshaft - but do ask the supplier!
Re: Ital 1300 spigot bearing
Posted: Sat Jul 06, 2013 1:26 pm
by southerly95
Thanks for reply, it looks like it is a standard fit on most 1275 engines and I think the 1st motion shaft is the same bearing face diameter, will check with them Monday.