Morris Minor Owners Club

Hi all.
I take the decisivos to rebuild my SMM'S engine!
Know I would Like to know the names of spare parts engine fo SMM model
Thanks in advance!
Michael Perry, I need again for your help!
Thanks in advance for your advises
Cheers
Carlos

Carlos move over here

And bring the sunshine with you

Hera at the moment is dark and rain cats and dogs!
But really I need your help!
Cheers
Carlos

Carlos PM Mike and don't forget to contact Bryan Gostling who nay be able to help.

ASL642 wrote:Carlos PM Mike and don't forget to contact Bryan Gostling who nay be able to help.

Thanks Lou for your help!
Cheers
Carlos

Which parts do you need. Put a request in the Wanted section here. Also contact all the traders. They often have second hand parts for sale.

Thanks Lou,
But at the moment I don't know what I wll need, because first I must desmantele the engine.
At the moment I know that I need new supports (rubbers) engine.
A soon I know what I need I will put in the link.

Cheers
Carlos

I am just going to rebuild my Series MM engine so tell me what you want and I will probably be able to tell you where to get it.
For a start you will need a complete gasket set, a clutch drive plate and thrust bearing and a set of con rod big end bolts. You will need to know what size pistons and crankshaft bearings are available before you have the engine rebored or crank reground. Also check the block for cracks.
What is wrong with your engine? Why are you rebuilding it? You have only just fitted a new cylinder head

Hi Michael,
I must rebuild the engine or rebore the block, because when I had the new head engine plausível new head gasket, there are a water leak between head and block , so it is necessary to rebore it.
And because I have a leak of power in one cylinder I' think is better to put news pistons and so on.....but of corse first we must desmantle the engine and we will see what are our needs.
Michael I will need your help!
For the moment can you find for me the available size for the pistons and crankshaf bearings?
Thanks in advance
Cheers
Carlos

Carlos - a water leak between block and cylinder head suggests the block may need to be surface skimmed - not 'rebored'. Assuming the 'new' head is flat of course. But of course it may also be a crack in either block or head.

bmcecosse wrote:Carlos - a water leak between block and cylinder head suggests the block may need to be surface skimmed - not 'rebored'. Assuming the 'new' head is flat of course. But of course it may also be a crack in either block or head.

Thanks Rob,
That is what I'm thinking ! But I must be prepared for the worst!
Thanks
Carlos

Sorry, Roy and not Rob!

How are you getting on with the engine?

mike.perry wrote:How are you getting on with the engine?

Is not yet dismonted I hope to have a list of my needs on next Monday!
A soon I know I will advise you.
Thanks for your help.
Cheers
Carlos