washer jets

[samuria]

when fitting these with new pipe and a push type pump and t-piece .
where does the one way valve go? or do i need 2?

[lambrettalad]

Morning,as long as it is fitted the right way around and before the pipe branches to each jet ,anywhere in the tube should work, I put mine in the container,so it was close to the pump.

[chesney]

I think there are two types of valve. One has a connection and a flat bottom, goes in the washer bottle at the end of the pipe. The other has two connections and is mounted in series with the pipe before the plunger, although I guess that could also get away with being at the base as long as it is fitted the right way round.

[samuria]

Morning,as long as it is fitted the right way around and before the pipe branches to each jet ,anywhere in the tube should work, I put mine in the container,so it was close to the pump.

my bottle is low down, off side inner wing.
would it be better to move to bulkhead nearside....

[lambrettalad]

I've see them in both positions with all sorts of bottles bags etc,mine is also in the same positions as yours ,works fine

[samuria]

thanks for that will see what happens

[mike.perry]

The bulkhead is the best position for the washer bottle, especially with electric washers