Morris Minor Owners Club

Hi i have the following parts for sale
1 pair of rear quarter glass with excellent rubbers £10.00 each
1 pair of rear quarter glass only £5.00 each
4 pairs of front vent glass £3.00 each
1 rear screen £30.00
1 starter motor lucus b90 exchange £40.00
1 bonnet pull £1.00
1 soliniod to starter cable new £5.00
1 screen washer plunger 50p
1 set of +50 main bearings £35.00
12 exhaust valves hardened new £2.50 each
4 exhaust inlet valves new £2.50 each
prop shaft bolts + steering second hand but good condition £2.50 a set
1 straight coil second hand painted in gloss black but good condition [carried as spare] £5.00
2 petrol chrome filler caps £1.50 each
1 pair of chrome screen surrounds [no clips] good condition £50.00

Regards
Barry

Hi,
I will definitely have the chrome windscreen surrounds please, also a filler cap. Have sent you a private message.
Thanks, Hazel

I would like 4 inlet and 4 exhaust valves new for MM. Not sure how to contact you can you Email me at family.chad@btinternet.com. Thanks Alan

Hi Glenacre
I will send you an E-Mail the valves you want i will put to 1 side for you
Regards
Barry

HI Glenacre
Just to let you now that i have posted the valves today

Regards
Barry

Hi manutd,are the front quarterlights painted or chrome please and from what year.
Regards smithskids.

can you post a photo of coil & solenoid to starter cable
Regards

Hi
It is the quarterlight glass that i have left, the frames have all been sold

Regards
Barry

ok Barry, thanks smithskids.

seriesmm_1 wrote:can you post a photo of coil & solenoid to starter cable
Regards

Sorry its took sometime to reply
I haven't got any photos of them, as they are over @ my parents. When i go over there i will get some for you.
If it helps the coil is the normal round 1& i have sprayed it in gloss black.
The soliniod to starter cable is a new 1

Regards
Barry

I am looking for the distributor extension shaft, for the sidevalve engine.
I have 2 and a half engine, but not a single shaft, is this one a part of your spares?

I have a spare jackshaft

PM send

TvdWerf wrote:I am looking for the distributor extension shaft, for the sidevalve engine.
I have 2 and a half engine, but not a single shaft, is this one a part of your spares?

No sorry the list above is all i have left

Regards
Barry

I may have such a shaft, out here in Melbourne, Australia. Should not be too bad to package and post, but can you scan to me a picture or diagram extract of the Manual showing it? PHIL pplumbe6@bigpond.com

What is the difference between the exhaust and inlet valves?
Only when the are used, I can see the difference.

I have 4 new valves found in a box with parts, but cannot see what they are.
Do you have 4 more?
then I can renew all of them ;)

Hi
Sorry it's taken a bit of time to get back to you
The exhaust valves have EX stamped on there head.
But it does not make any different's which valve goes where as they are all the same size & lengh
I have 4 exhaust hardened valves & 2 inlet valves left

Regards
Barry

Because I have 2 engines, and the 4 other new valves does not have the ex mark, I like all the 6 valves ;)

I send a PM for the other information.

TvdWerf wrote:Because I have 2 engines, and the 4 other new valves does not have the ex mark, I like all the 6 valves ;)

I send a PM for the other information.

I have sent you a PM

Regards
Barry