Page 1 of 1
VIN PLATE
Posted: Fri Mar 16, 2012 3:00 am
by steve c
just got a new VIN plate to replace the un readable original, now not sure how to get it stamped up with chassis number, can anyone help on this.
regards Steve
Re: VIN PLATE
Posted: Fri Mar 16, 2012 8:37 am
by mattsw
You can buy a set of punches you just hit with a hammer from machine mart etc, but have a practice first cant always get them in line, unless you make a little jig and buy the right size, or do what other people have done and get it engraved, may not look original but will be very neat. Part of my job is engraving and I have done a few from MGs to land rovers even trailers! so if you dont fancy the punches try your local trophy shop/engravers. good luck
Matt
Re: VIN PLATE
Posted: Sun Mar 18, 2012 5:37 pm
by mike.perry
Keep the old plate as evidence of true identity, even if it is unreadable. Some people like me get suspicious about shiny new plates, particularly on "convertibles".
Re: VIN PLATE
Posted: Sun Mar 18, 2012 8:46 pm
by a8pte
do what i just done take the new plate to a key cutting shop who does engraving and they will do it for you mines fab cost me £8.00
Re: VIN PLATE
Posted: Mon Mar 19, 2012 7:44 pm
by bmcecosse
Minors don't have 'VIN' numbers.....
Re: VIN PLATE
Posted: Mon Mar 19, 2012 11:21 pm
by lambrettalad
for all intense and purposes ............
Re: VIN PLATE
Posted: Mon Aug 06, 2012 10:48 am
by whyperion
N/S Bulkhead Plate - Decoding Please ?
My plate - I have unscrewed it to give it a clean reads Z36055 what does this mean ? then 493921 which I assume is a body number for that type of body ( 2 door saloon ) its off an F reg 2 door so the number reads about right given the total post war Minor production of all types.