Page 1 of 1
etch
Posted: Sat Mar 03, 2012 7:36 pm
by les
Is it usual to put a coat of celly primer over a surface of etch primer?
Re: etch
Posted: Sat Mar 03, 2012 7:55 pm
by customjob
Not normally from my experience, some people say yes, I've never done it but then i was taught not too.
Re: etch
Posted: Sat Mar 03, 2012 8:04 pm
by les
Well I've applied 2 coats of etch so will leave it at that. thanks.
Re: etch
Posted: Sun Mar 04, 2012 8:13 am
by tysonn
Etch primer is very thin.Its probably wise to give a few coats of primer filler that you can then wet sand to get a really smooth surface for your top coats.
Re: etch
Posted: Sun Mar 04, 2012 9:33 am
by kennatt
etch primer is used to give a sound base on bare metal for primer filler,not normally used on its own,how can you flat it down,which you need to to put the top coat on,without risking doing down to bare metal again,never known it to be used on its own,but may be ok,I would'nt risk it myself,top coat paint is too expensive to have to redo.
Re: etch
Posted: Sun Mar 04, 2012 4:33 pm
by Neil MG
As above, the etch is a surfacer for the steel to get a good bond and while it can also be used as a primer it is nor really suitable for bodywork as it will not fill imperfections. It might not be the best surface in any case depending upon your chosen top coat.
That said, it is fine for brackets etc. that don't need a high quality surface finish.