Page 1 of 1

Can anybody help? (series 2 dash panel)

Posted: Tue Jan 31, 2012 8:38 pm
by Boomlander
Hi Folks,
Can anyone tell me where I can obtain the small cylindrical spring rings that fit on the locating pegs of the central ribbed dash panel on a series two Moggy?
Mine has two missing and the panel holds on very loosely with just one peg located firmly into its hole.
Maybe there is another solution....Shrink tubing, Blu Tack etc.?
Advice as always greatly appreciated!

Re: Can anybody help? (series 2 dash panel)

Posted: Wed Feb 01, 2012 12:04 am
by mike.perry
Try a hardware shop. My grill stays in place without clips, I have to gently lever it in with a screwdriver

Re: Can anybody help? (series 2 dash panel)

Posted: Fri Mar 30, 2012 12:08 pm
by Boomlander
Fitted the three locating pegs with a small length of heat shrink tubing,
Panel fitted smoothly and tightly into position - what a result! :P[frame]Image[/frame]

Re: Can anybody help? (series 2 dash panel)

Posted: Sat Mar 31, 2012 9:22 pm
by mike.perry
Nice carpets, where are they from?

Re: Can anybody help? (series 2 dash panel)

Posted: Sat Mar 31, 2012 9:30 pm
by Boomlander
mike.perry wrote:Nice carpets, where are they from?
They were in the car when I bought it, I assumed they were just generic type carpets.
I noticed there was no underfelt though so I've bought a pack of it and will give the carpets a thorough clean and vac before they go back in - I'm afraid the driver's side has got a bit grubby with me messing about under the dash panel. :oops: