Which side where??!

Discuss Bodywork problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Which side where??!

Post by Arthurdaily »

HMnnn.... so you buy felt / bitumen pads for sound deadening and insulation... but here is a stupid question... which side do you glue to the bodywork? The felt / jute side or the bitumen side??? :-?
irmscher
Minor Legend
Posts: 3773
Joined: Wed Jul 14, 2010 10:53 am
Location: South Manchester
MMOC Member: Yes

Re: Which side where??!

Post by irmscher »

the side with hard surface :lol: :lol:
Neil MG
Minor Legend
Posts: 1116
Joined: Sat Jan 15, 2011 8:05 am
Location: Cumbria
MMOC Member: No

Re: Which side where??!

Post by Neil MG »

Yes, the bitumen side.

Make sure you don't use this kind of insulation in any areas that can get wet. If your car is kept outside, then with condensation that's almost everywhere! Also not a good idea to use on the underside of panels (E.g. bonnet and roof) as it is quite heavy and when it gets hot or aged it can fall off.

Er, do you get the impression that I don't recommend this particular stuff for a Minor? Definitely not a daily (all weather) driver.
1956 Morris Minor Series II
1959 MGA 1600 Roadster
1966 Jaguar Mk2 3.8 MOD
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Hmnnn.... what would you recommend then? Simply felt / jute - or is that the problem. I know this has been covered before - but am having trouble finding stuff that isn't jute type - would you think closed foam sheets are better - they are insulating and don't soak up water!
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Oh, and what about carpet underlay then? Presumably that is the same - a felt / jute would soak up water but that is what is sold for Minors on esm etc... again would closed cell foam sheeting be better?
MarkyB
Minor Maniac
Posts: 7845
Joined: Thu Jan 25, 2007 3:18 pm
Location: South East London
MMOC Member: No

Re: Which side where??!

Post by MarkyB »

There are other types of sound insulation available, more along the lines of self adhesive roof flashing, stick on lead type stuff in short.
Can be pricey, but shouldn't hold any water :)

"Once you break something you will see how it was put together"
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

How about this... quite light. might be good for the roof?

http://www.ebay.co.uk/itm/30sqm-airtec- ... 2a19050cba
irmscher
Minor Legend
Posts: 3773
Joined: Wed Jul 14, 2010 10:53 am
Location: South Manchester
MMOC Member: Yes

Re: Which side where??!

Post by irmscher »

It would be ok far a garage :o and far too expensive
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Hmnnn... other types of car roof insulation is even more expensive! In fact I have just found that this is what a lot of vw owners line their vans with, or similar stuff anyway. There appears to be nothing on the market specifically designed for the roofs EXCEPT for jute type material or lining carpet which is even more expensive.
irmscher
Minor Legend
Posts: 3773
Joined: Wed Jul 14, 2010 10:53 am
Location: South Manchester
MMOC Member: Yes

Re: Which side where??!

Post by irmscher »

What is Derek using Axminster :lol: Look at the stuff the custom guys use for there sound systems to stop the resonation brilliant stuff and cheap.
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

?? A lot of people in the VW world DO use carpet yes, and in the land Rover world too - often used on the roofs to stop condensation when used as a daily driver as there is no head linings on the series landies - so axminster would be fine! Though a little heavy, you'd need good glue :D .

Where, Lee, is all this super cheap insulating material? Double foil bubble insulation, as in the link, would cost only about 18 quid for the whole roof, is 4-5mm thick, highly insualting, very very light and totally waterproof.

Could you send me a link to what the custom chaps use? I can't find it! :(
Neil MG
Minor Legend
Posts: 1116
Joined: Sat Jan 15, 2011 8:05 am
Location: Cumbria
MMOC Member: No

Re: Which side where??!

Post by Neil MG »

1956 Morris Minor Series II
1959 MGA 1600 Roadster
1966 Jaguar Mk2 3.8 MOD
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Thanks Neil, yes I have seen some of these - and some of them are good for certain areas of the car, even the roof in some instances - but for the whole car all are quite expensive, in comparison to foiled bubble wrap anyway lol, that is my point to Irmscher - he criticised a product that only cost 18 quid for the whole car... I'm still waiting for his link to something that is as good but as cheap / cheaper...

That last ebay link does look very interesting though Neil... 32 square feet... must measure the saloon... :D
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Neil, do you think those pads (ebay link) would be okay for the roof??
Neil MG
Minor Legend
Posts: 1116
Joined: Sat Jan 15, 2011 8:05 am
Location: Cumbria
MMOC Member: No

Re: Which side where??!

Post by Neil MG »

I have not used it, but I see no reason why not. I wonder if you could get a sample first?
1956 Morris Minor Series II
1959 MGA 1600 Roadster
1966 Jaguar Mk2 3.8 MOD
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Good idea - I'll email 'em. Thanks again Neil
irmscher
Minor Legend
Posts: 3773
Joined: Wed Jul 14, 2010 10:53 am
Location: South Manchester
MMOC Member: Yes

Re: Which side where??!

Post by irmscher »

I didnt critiscise Mathew :roll: Go to one of the car audio shops in Stockport one that does boot installs they have loads of off cuts and full pieces of sound deadening products .The Minor lends itself to piecing so is easy and can be covered i have done mine this way for £10 and under the dash etc .
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Thanks everybody for your advice - I have purchased two rolls of aluminium backed flashing for various panels, plus a pile of insulation off ebay which was linked to on here...

BUT back to my original question on felt / bitumen sound proofing / insulation... the answer came back that the 'hard 'side goes against the metal... but having gone back thorugh various books and looked at what is left of the original stuff behind the dash of two minors it seems that the felt side is against the bulkhead from the factory?

I'm confused?
irmscher
Minor Legend
Posts: 3773
Joined: Wed Jul 14, 2010 10:53 am
Location: South Manchester
MMOC Member: Yes

Re: Which side where??!

Post by irmscher »

That is when it is non bitumen backed.
Arthurdaily
Minor Addict
Posts: 636
Joined: Tue May 24, 2011 4:25 pm
MMOC Member: No

Re: Which side where??!

Post by Arthurdaily »

Ahh... what is it backed with then... it sort of feels bitumany.. ish.. lol
Post Reply