Page 1 of 1
Fitting new coolant pipes...
Posted: Wed Dec 28, 2011 9:38 pm
by Arthurdaily
When fitting new coolant pipes a chap I know rubbed the ends of the pipes, and all water gaskets, with this red sealant stuff - I can't ask him at the moment, but does anybody have an idea what it might have been??
Re: Fitting new coolant pipes...
Posted: Wed Dec 28, 2011 10:46 pm
by les
I'd say it was gasket sealant, I think the red stuff sets hard, blue is better as it's non setting. I can't think why he wanted to put it on rubber hoses, sounds messy and unnecessary.
Re: Fitting new coolant pipes...
Posted: Thu Dec 29, 2011 3:47 pm
by katy
Possibly red silicone gasket sealer.
Re: Fitting new coolant pipes...
Posted: Thu Dec 29, 2011 6:07 pm
by JOWETTJAVELIN
I have just had to remove a load of this crud when changing some gaskets - round the rocker cover and heater tap, and it was like cement. I don't think there's any call for it as long as the joining surfaces are smooth. I'm doing fine without it and Staton Abbey says there's no need to use it!
Re: Fitting new coolant pipes...
Posted: Thu Dec 29, 2011 7:05 pm
by les
Allegros are alive and well in paradise then?
Re: Fitting new coolant pipes...
Posted: Thu Dec 29, 2011 7:34 pm
by JOWETTJAVELIN
Indeed they are! It's gone to a good home now, but during the last 2 years whilst at university I put 10,000 miles on the thing... it never broke down. It was a good car, v. comfortable but some spares expensive.
Re: Fitting new coolant pipes...
Posted: Thu Dec 29, 2011 7:36 pm
by bmcecosse
Certainly a much better car than the ghastly Marina !
Re: Fitting new coolant pipes...
Posted: Thu Dec 29, 2011 7:43 pm
by les
I've had a couple of estates, great cars.
Re: Fitting new coolant pipes...
Posted: Fri Dec 30, 2011 10:02 am
by MarkyB
does anybody have an idea what it might have been??
Red Hermatite would be my guess, dreadful stuff, bodgers delight.