Page 1 of 1
front panel
Posted: Thu Dec 15, 2011 4:17 pm
by minor 62
hi i have my minor going back together again after 2 replacement front wings,(second hand genuine wings) the inner wings were not touched at the front but the original front panel does not line up with the holes for the hockey sticks, is there a trick to replacing this panel, or am i just stupid, thanks in advance for your help, michael (minor 67)
Re: front panel
Posted: Thu Dec 15, 2011 6:01 pm
by bmcecosse
You probably need to slacken everything -podger it into place including the hockey sticks, and then finally tighten everything up when it's all fitting reasonably.
Re: front panel
Posted: Thu Dec 15, 2011 10:10 pm
by les
If you pull or push the wing at a point above the wheel the holes at the front should, at some point, line up with the front panel. Doing this will also alter the gap between door and wing, so you need to watch that.
Re: front panel
Posted: Fri Dec 16, 2011 5:03 pm
by minor 62
hi thank you for your help, i wasnt sure if i had to push the wings together or if there was something wrong, i will give that a try over the weekend
Re: front panel
Posted: Wed Dec 21, 2011 8:15 pm
by minor 62
front panel now back on the minor thank you all for your help