new loom
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
gyro
- Minor Friendly
- Posts: 30
- Joined: Wed Oct 12, 2011 9:39 pm
- Location: punta gorda, florida,USA
- MMOC Member: No
new loom
received the new loom yesterday, wire color coded, found diagram online. Question is. Do we start at the foward or aft? Or possible in the middle at control box and work out?
If it isn't broken, don't fix it
-
beero
- Minor Legend
- Posts: 1207
- Joined: Sun Jun 20, 2010 10:43 pm
- Location: Chichester
- MMOC Member: No
Re: new loom
The difficult part is where it goes through the bulkhead.
Fit it there and then connect to control box and fuses, then do the dash wiring, the rest will be easy.
Fit it there and then connect to control box and fuses, then do the dash wiring, the rest will be easy.
-
mike.perry
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: new loom
Lay it out on the floor so that you can identify the wires before you try fitting them. Check the bullet connectors as you go.
Keep the old loom, it is always useful for stripping spare bits of the correct colour wires
Keep the old loom, it is always useful for stripping spare bits of the correct colour wires
[sig]3580[/sig]