Page 1 of 1
Clutch link sidevalve
Posted: Mon Aug 15, 2011 8:21 pm
by sevrien
Hi,
My clutch link (thin rod coming from the pedal) just broke down.
Can somebody tell me which part I need to order on ESM or Bullmotive?
thanks
Re: Clutch link sidevalve
Posted: Mon Aug 15, 2011 10:02 pm
by mike.perry
The Moss catalogue does not list the 918 linkage. I would suggest that it is easy enough to get one made and maybe cheaper to have a few made, keep a spare and sell the rest to recoup your expenditure as the setting up the tooling is the expensive bit.
Or try MMOC Club Spares.
Re: Clutch link sidevalve
Posted: Tue Aug 16, 2011 10:34 pm
by bmcecosse
Can you not fabricate something at least temporarily meantime - from some 8mm threaded bar ? Can you show us a picture of the offending item ??
Re: Clutch link sidevalve
Posted: Wed Aug 17, 2011 7:45 pm
by MarkyB
A plastic cable tie, or two, work great!
Re: Clutch link sidevalve
Posted: Fri Aug 19, 2011 9:31 am
by RobThomas
If it is the 15cm long rod with 2 bent ends then I'd recommend 2 flat pieces of sheet steel and 2 bolts with a section of plain shaft. Does this make sense? The bent rod will be hard to make and is likely to wear out again fast.
Re: Clutch link sidevalve
Posted: Fri Aug 19, 2011 1:48 pm
by minor_hickup
Re: Clutch link sidevalve
Posted: Fri Aug 19, 2011 3:36 pm
by mike.perry
[frame]
[/frame]
Which part is broken, 39 or 42?