Page 1 of 1
Traveller Wing Beading
Posted: Mon Aug 01, 2011 9:50 pm
by GPO_Van
Hi All
Another question, I have ordered Traveller Wing Beading and was wondering if I should be using any sort of sealant between the wood and beading and the wing and beading when fitting, if so, any recommendations?
Thanks
Reg
Re: Traveller Wing Beading
Posted: Mon Aug 01, 2011 11:46 pm
by irmscher
You dont realy need it but clear silicone is good
Re: Traveller Wing Beading
Posted: Tue Aug 02, 2011 10:38 am
by ASL642
Nothing needed and some silicone sealants can remove the paint - be careful.
Re: Traveller Wing Beading
Posted: Tue Aug 02, 2011 8:01 pm
by simmitc
When fitting the beading, a staple gun is a very useful tool, along with scissors and knife. You should see on the old beading that you need to cut "V" sections to allow the beading to turn the corner at the front edge, and also need to cut holes to allow the bolts through.
Re: Traveller Wing Beading
Posted: Wed Aug 03, 2011 8:48 pm
by GPO_Van
Hi
Now beading has arrived I can see a staple gun is easier than a hammer and nails, unless of course you have three hands
I will put some sealer in and be careful of my paintwork
Thanks for all your advice
Reg