Page 1 of 1
Kick plates/sills?
Posted: Fri May 27, 2011 4:04 pm
by Mandymoo
hi all..Iv noticed the kickplates..or what I think are kick plates are bolted onto the car (1960 model morris 1000)..yes Im referring to the bit above the sills where the door opens.(on body not door)..just wondering are these easy to remove and reinstall?..as I am doing some surface rust removal and want to get into the corner fiddly bits..any replies appreciated
Re: Kick plates/sills?
Posted: Fri May 27, 2011 4:58 pm
by mike.perry
They just sit over the sills, remove any screws and they should lift off. Hopefully you will not get too much of a shock when you see inside

Re: Kick plates/sills?
Posted: Sat May 28, 2011 9:19 am
by Mandymoo
thank you ..will keep my fingers crossed

Re: Kick plates/sills?
Posted: Sat May 28, 2011 12:38 pm
by mogbob
Mandy
To elaborate on Mike's answer there are self tapping screws " inside " the car where the kick plates hook over the bodywork.
Gently tap the end of the screwdriver to shock them loose/ get started.
Underneath the car,a couple of inches/ 5cm, inboard of the sill finishers you will find four small nuts and bolts.The bottom edge of the kick plate is sandwiched between the sill finishers and the sill.
Being underneath the car, exposed to all the elements....you can guess what I'm going to say next ....getting the nuts and bolts undone may prove a bit of a challenge.Certainly wire brush well and soak with Plus gas and have a go but most people attack it with a cold chisel and hammer, if you are careful, or an angle grinder for speed.New nuts and bolts required.Re-Install with grease / copperease for future protection.
Bob
Re: Kick plates/sills?
Posted: Sat May 28, 2011 6:58 pm
by morris1961
i spent hours taking these off my moggie today!
Re: Kick plates/sills?
Posted: Sun May 29, 2011 11:09 am
by mogbob
Every experienced restorer of classic cars immediately knows that " remove fixing screws" = lots of time and effort.
Bob
Re: Kick plates/sills?
Posted: Wed Jun 01, 2011 4:01 pm
by ian.mcdougall
Tap head of screw side to side to make it easier to remove replace with new screw and make sure you use correct type and size of screwdriver
Re: Kick plates/sills?
Posted: Tue Dec 06, 2011 2:50 pm
by Mandymoo
thanks everyone & please forgive the delayed response, but I am happy to say that the job was quite easy and underneath ..."NO RUST!!!!"...I think my car has been protected by clay that seems to be 50 years old and an inch thick

Re: Kick plates/sills?
Posted: Tue Dec 06, 2011 4:15 pm
by mogbob
"No rust " ?
You own a very special Morris !! Joking apart..glad it all went well.Hope the protection lasts for another 50 years.
Safe motoring
Bob
Re: Kick plates/sills?
Posted: Tue Dec 06, 2011 4:38 pm
by bmcecosse
Hope you loaded it all with waxoyl while you were in there.