Page 1 of 1
lights
Posted: Sun Apr 03, 2011 4:35 pm
by tomas.geoghegan
Hi Please could you help.
my side lights and head lights have decided not to work.
when switched on And now indicators have decided not to work ether.
i have changed the fuses and cleaned the fuse holders with sand paper.
All the wireing seems to be conected and the earths seam ok
and just to add there is no main beam warning light as well.
All dead as a dodo
Best Regards Fellow moggie man Tom Geoghegan
THANKS
Re: lights
Posted: Sun Apr 03, 2011 5:02 pm
by Neil MG
check the connections to the lights switch, all the lights take their power from there and, given you checked the rest, it sounds like a wire loose. If not there, then check the ignition switch.
Re: lights
Posted: Sun Apr 03, 2011 5:40 pm
by tomas.geoghegan
Hi Thanks will check That tomorrow.
Best Regards
Tom
Re: lights
Posted: Sun Apr 03, 2011 10:12 pm
by bmcecosse
Look to the connections on the voltage regulator......
Re: lights
Posted: Sun Apr 03, 2011 10:23 pm
by mike.perry
The side lights are on a separate in line fuse (1098 only) and the headlights are not fused. Check the feed wire to the light switch, brown/blue. Ignition will not affect side/headlights
Indicators are a separate problem, switch on ignition and wipers to check fuse.
Check green wire to term B on flasher is live, if yes connect green wire to green/brown wire and indicate left or right. Indicator lights should be on but not flash. If so replace flasher unit.
Check brake lights
Re: lights
Posted: Mon Apr 04, 2011 6:29 am
by tomas.geoghegan
THANKS FOR YOUR HELP I WILL KEEP YOU POSTED ON HOW I GET ON
Regards Tom
Re: lights
Posted: Mon Apr 04, 2011 4:09 pm
by tomas.geoghegan
Hi Iv checked the brake lights and they work. and a dirty conection was stoping the indercaters.working.
To check the light switch on dash boad i need to remove it. But i cant get the black nob off .I think there is a pin there?
Any tips Please
Thanks
Best Regards Tom
Re: lights
Posted: Mon Apr 04, 2011 4:23 pm
by Neil MG
Yes, push in the pin in on the underside of the black knob and the knob will then pull off. You can then unscrew the chrome bezel and the switch can be withdrawn from behind!
Re: lights
Posted: Mon Apr 04, 2011 5:06 pm
by tomas.geoghegan
Thank you Very much
Best Regards Tom
Re: lights
Posted: Fri Apr 08, 2011 1:34 pm
by tomas.geoghegan
Thanks for all the help.
just to round things up it was a loose wire on the control box.
fantastic support
Best Regards Tom moggie 948 Geoghegan :
Re: lights
Posted: Fri Apr 08, 2011 11:30 pm
by bmcecosse
Re: lights
Posted: Sat Apr 09, 2011 12:10 am
by beero
bmcecosse wrote:Look to the connections on the voltage regulator......
Well done
