Page 1 of 1
Engine floor Turned-up section
Posted: Mon Feb 21, 2011 6:01 pm
by croft
Hi all, after fitting a new floor section to the engine bay I have just been informed I need to "turn up" a section so that the oil filter doesnt hit! Do I have to do this? If so could someone post a pic or some measurements of where the "turn-up" section needs to be. Thanks in advance
Re: Engine floor Turned-up section
Posted: Mon Feb 21, 2011 6:50 pm
by taupe
Here is a pic of it on ptitteringtons pick up chassis - its in the same place on the saloon and traveller
Its simply hammered up to make room for the oil filter to fit
Re: Engine floor Turned-up section
Posted: Mon Feb 21, 2011 10:30 pm
by bmcecosse
I think most are hammered down, rather than up ?
Re: Engine floor Turned-up section
Posted: Tue Feb 22, 2011 4:52 pm
by aupickup
mine is original and hammered up