Page 1 of 1
Rear chassis spring hanger repair panel
Posted: Mon Feb 14, 2011 7:17 pm
by southerly95
I bought one of these today but looking down the length of it, the tube that takes the shackle pin and rubber bushes is not at right angles to the vertical, it's probably 10 degs out. I think it should be at right angles - could someone confirm which is correct, thanks, John
Re: Rear chassis spring hanger repair panel
Posted: Mon Feb 14, 2011 8:31 pm
by moggyadventurer
Hi,
Can't really help with the angle at the moment - will have a look tomo, but be aware this repair panel quality is very poor. I had three from BM before finally getting one with the correct angle. Sri Lanka ones seem worse than the few lmc still kicking around.
Re: Rear chassis spring hanger repair panel
Posted: Tue Feb 15, 2011 1:26 pm
by rayofleamington
yes it should be square and not 10 degrees off.
Re: Rear chassis spring hanger repair panel
Posted: Tue Feb 15, 2011 7:21 pm
by RobMoore
You would think that traders would check these kinds of things before dispatch tbh.
I refuse to have anything made abroad due to such sub standard workmanship, sure we may be nation of moany grumpy gits but at least we know how to make things
Re: Rear chassis spring hanger repair panel
Posted: Tue Feb 15, 2011 9:23 pm
by southerly95
Thanks for replies, the nice people at DSN swapped it for another one today, this time with everything in the right place, regards, John