Sump gasket, 1275 engine
Posted: Tue Jan 04, 2011 11:45 am
Further to the big end bearing story.....
the sump, when I removed it, has rubber seals at the front & rear ends. These are located on a series of little pins which protrude from the locating slots on the sump.These rubber seals are NOT shown in the Marina manual
The new replacement I have got has the cork seals as usual.The side gaskets are the same on both old & new gasket sets.
I am wondering if I should replace the original rubber ones or try to use the new cork ones?
Advice from learned counsel would be appreciated!
Chris
the sump, when I removed it, has rubber seals at the front & rear ends. These are located on a series of little pins which protrude from the locating slots on the sump.These rubber seals are NOT shown in the Marina manual
The new replacement I have got has the cork seals as usual.The side gaskets are the same on both old & new gasket sets.
I am wondering if I should replace the original rubber ones or try to use the new cork ones?
Advice from learned counsel would be appreciated!
Chris