Page 1 of 1
GEAR LEVER SPRING AND DISTRIBUTOR PLATE
Posted: Wed Dec 08, 2010 4:47 pm
by AJFMOTORENGINEERSLTD
Hi there thank you to all of you who have helped me get bits before.
1950 sidevalve Morris Minor
i now need a gear lever spring (cone type that sits underneath ) the gear lever and a distributor spacer plate that has a single bolt to secure it to the cylinder head
can you help
Adrian j Fell AJF MOTOR ENGINEERS Ltd
Re: GEAR LEVER SPRING AND DISTRIBUTOR PLATE
Posted: Wed Dec 08, 2010 9:17 pm
by mike.perry
Gear lever turret spring available from Bryan Gostling, MMOC Spares. Make sure that the rods are in line with the box in neutral when you refit the top plate and gear lever, and don't lose the detent springs and ball bearings in the gearbox
Distributor clamp plate - ask Bryan or put a request on the Series MM Noticeboard
Unlike the A Series box the MM gearbox uses EP90 gear oil
Anything else you require?
Re: GEAR LEVER SPRING AND DISTRIBUTOR PLATE
Posted: Thu Dec 09, 2010 9:13 am
by AJFMOTORENGINEERSLTD
hi am i stupid or is there an easy way of messaging Bryan?
Re: GEAR LEVER SPRING AND DISTRIBUTOR PLATE
Posted: Thu Dec 09, 2010 1:04 pm
by LouiseM
Just use his e-mail address as shown in Minor Matters. I don't have a copy to hand at the moment but it will be shown on the club information page near the front of the magazine and also on the club spares page. Or if you go to the Club Spares section in the 'Members Area' on this messageboard there's a link to send him an e-mail.