Page 1 of 1
It's stuck !
Posted: Thu Oct 07, 2010 1:20 pm
by Peetee
I'm trying to remove the water pump pully. The yellow body is loose but the small round centre bit is stuck. I've tried plusgas but it won't budge. Never come across this problem before. Do i resort to the hammer or will that knock it home further?
Re: It's stuck !
Posted: Thu Oct 07, 2010 2:57 pm
by bmcecosse
Just knock it about gently - the yellow pulley is just a push fit over the nose of the pump. I'm assuming you have the four screws out......
Re: It's stuck !
Posted: Thu Oct 07, 2010 5:34 pm
by Peetee
Yes the yellow part is loose and able to revolve around the boss of the pump,ie: go out of line with the bolt holes. The problem is a unpainted centre 'hub' that appears to be part of the pully but is stuck on or in the end of the pump behind.
Re: It's stuck !
Posted: Thu Oct 07, 2010 9:49 pm
by bmcecosse
The pump boss is one piece - just yank the pulley off!
Re: It's stuck !
Posted: Thu Oct 07, 2010 11:32 pm
by Peetee
So that plain metal bit in the centre is part of the pump? In other words when the pulley comes off there will be a 1/2 inch hole in the centre?
Re: It's stuck !
Posted: Fri Oct 08, 2010 7:49 am
by sirrom
Yes the hole is in the centre of the pulley
Re: It's stuck !
Posted: Tue Oct 12, 2010 5:13 pm
by Peetee
It's off now but the problem was that centre boss.It was a bit on the large size to get the pully off cleanly. Done this job about a half dozen times before and never come across this.
We live and learn.
Re: It's stuck !
Posted: Tue Oct 12, 2010 7:40 pm
by bmcecosse
Probably an excess of paint. Just run a half-round file round the hole.
Re: It's stuck !
Posted: Tue Oct 12, 2010 8:07 pm
by Peetee
Good plan. Cheers Roy.