Page 1 of 1

new guy in oregon

Posted: Sat Sep 11, 2010 7:53 pm
by bigscooter
hello everyone, i'm new to this forum, i'm in oregon USA, and i've recently purchased a 1961 morris minor that's worth bringing back from the dead(i hope). it's my first morris so please forgive me when i ask stupid questions :)
i just replaced a bad generator(dynamo?) with a good used alternator. is it better to keep the existing voltage regulator, or delete it? is there a good diagram someone might point me to for deleting it? i did find one that leaves the regulator mostly intact.
thanks!

sean

Re: new guy in oregon

Posted: Sat Sep 11, 2010 8:13 pm
by RobMoore
Welcome to the forum.
I have alternator and regulator

Re: new guy in oregon

Posted: Sat Sep 11, 2010 9:28 pm
by Dryad
Hi, welcome to the forum! I have a '62 Minor with an alternator but no reg box, so it seems it can be done either way. I expect someone will be along here soon who can give you more information.

Re: new guy in oregon

Posted: Sat Sep 11, 2010 9:35 pm
by bmcecosse
Welcome to the forum - the regulator can be kept as a 'junction box' only - it doesn't regulate the alternator in any way! In UK we would need to convert the car to -ve earth before fitting an alternator.[frame]Image[/frame]

Re: new guy in oregon

Posted: Sun Sep 12, 2010 12:56 am
by bigscooter
bmcecosse wrote:Welcome to the forum - the regulator can be kept as a 'junction box' only - it doesn't regulate the alternator in any way! In UK we would need to convert the car to -ve earth before fitting an alternator
yes, i did convert it, after doing some reading here on the forum. i do still need to clean my ignition points though.
on the diagram below, do you think i can conect the "D" wire to the "A" junction, and the "F" wire to the "D" junction in order to use the existing dynamo wires for the alternator?
[frame]Image[/frame]

Re: new guy in oregon

Posted: Sun Sep 12, 2010 6:26 am
by bmcecosse
YES - cleaqn the ignition and fuel pump points - yes, you can use the old dynamo wires but wire up as shown on the diagram only.