Page 1 of 1
BBQ: Gear on flywheel
Posted: Thu Mar 18, 2004 7:35 pm
by Theo
I'm probably not the only one with the problem of putting a new gear on the flywheel.
This is the way I did it
:
http://www.chello.nl/~t.vandevelde1/flywheel.htm
Posted: Thu Mar 18, 2004 7:39 pm
by Theo
Sorry, this might work:
(look at "new gear at flywheel")
http://members.chello.nl/~t.vandevelde1
Posted: Thu Mar 18, 2004 7:48 pm
by Alec
Hello Theo,
I normally drift them on and off with a hammer and punch.
Alec
Posted: Thu Mar 18, 2004 7:54 pm
by Theo
Alec,
That's the easy way. I first always try the hard way (this was my first)
Fitting a new ring gear.
Posted: Fri Jun 25, 2004 11:25 pm
by dawpooldad
Theo, Alec, everybody,
I had access to full workshop facillities, but I managed it with a small gas ring on the stove. The trick is:- Put your flywheel in the freezer compartment (suitably wrapped up so that it doesn't stick to anything!) for a few hours before so that it contracts. Then you dont have to overheat the ring to get it on.
Regards
Dawpooldad.
Wirral