Morris Minor Owners Club

Hi I have just started to put the front suspension back on my project after leaving it all winter, the question I have is when I refit the trunions how far do I wind them on to the king pin

thanks

Tony

I normally wind them all the way up then back a turn.

As far as they will go and point in the right direction....

As Marky B, I sqirt in a blob of grease into the trunnion first. Check for play on the trunnions, do not fit them if you can detect any wobble or free play.

Back off one turn - to be sure they can freely rotate. If they are then 'slack' on the thread - they need renewing - possibly (actually - probably!) also a new king pin.

When you push the fulcrum pin through the trunnion, it should be centred in the grove on the kingpin.

Pack the trunnions with grease before you wind them on

Maybe rinse them out first as well. The last ones I fitted were full of swarf.

Thanks for the all the advice put the one side back on today bit of a strugle with the car on its side but managed in the end. I will do the other side once the car is back on all four wheels
thanks again
Tony

No swarf in this one;[frame][/frame]

No thread either .
Take nothing for granted.

Replaced, no problem, except not until I'd returned this one.
No names, no pack drill.

Put in plenty of grease threads looked like new on kingpins fitted new rubber seals and polybushed no play at all on threads hopefully the other side will be as good

Tony

" No thread either " Crikey! What price quality control ????????