Page 1 of 1
Carb mounts (bmcecosse)
Posted: Thu Jun 03, 2010 10:28 pm
by RobMoore
Here are pics of my carb hole and the filter
Carb hole[frame]
[/frame]
Air filter case[frame]
[/frame]
I found this in my box of spares.[frame]
[/frame]
Re: Carb mounts (bmcecosse)
Posted: Thu Jun 03, 2010 11:31 pm
by bmcecosse
Can't really see - it just looks like the mounting plate for the filter, may have a smaller inlet hole than the carb inlet. You would need to un-do the two screws and remove it - then measure the hole sizes!
Re: Carb mounts (bmcecosse)
Posted: Fri Jun 04, 2010 10:04 pm
by RobMoore
They do appear to the same size but my sight aint what it was.
when fitted I can feel a slight lip though probably about 1 mil
[frame]
[/frame][frame]
[/frame]
btw, is the filter seated in the correct manner?[frame]
[/frame]
Re: Carb mounts (bmcecosse)
Posted: Fri Jun 04, 2010 11:14 pm
by bmcecosse
Well - any lip is bad news - so file it out!