Page 1 of 1

New Member - 1st question - tape measure required

Posted: Tue May 18, 2010 4:02 pm
by SimonWH
Hi

1st question. We're thinking of getting a traveller after owning saloons and a tourer in the past. But I need to know the dimensions of the rear load area.

Could someone measure the width and height if the 'usable' rear loadspace or point me to the info?

We have a collapsable display unit that we need to fit in the back from time to time so I want to know if it fits.

Cheers in advance

Simon

Re: New Member - 1st question - tape measure required

Posted: Wed May 19, 2010 6:37 am
by charlie_morris_minor
where abouts do you live?

if you live near aldershot you are more than welcome to come and try and fit it in my traveller,

i will measure up over the weekend

Re: New Member - 1st question - tape measure required

Posted: Thu May 20, 2010 11:08 am
by SimonWH
Thanks

We're in Orpington, Kent. I've been looking around but can't seem to find a Traveller anywhere. Might have to make a trip over to one of the dealers.

Cheers

Simon

Re: New Member - 1st question - tape measure required

Posted: Sat May 22, 2010 7:26 pm
by charlie_morris_minor
the following measurements..

depth is 125cm
width is 118cm but at floor level the wheel arches take out 12cm on either side of the car
height is 76 in the middle

hope that is of some help to you..

Re: New Member - 1st question - tape measure required

Posted: Sat May 22, 2010 7:34 pm
by alex_holden
Morris Minors, especially Travellers, are a bit like a TARDIS - the inside expands to just fit whatever you need to carry in them! :D

Re: New Member - 1st question - tape measure required

Posted: Mon May 24, 2010 5:08 pm
by SimonWH
Many thanks for the measurements. :D