Morris Minor Owners Club

I've got a bunch of Fiat engines most with worn bores but I've had no luck getting oversize 2-litre pistons. I don't want to run forged pistons as it's a budget engine - eventually I'll stick a zetec in it, so, any ideas?

Cheers,

Jon

As you say, forged are expensive
http://www.performanceenginecomponents. ... .asp?id=94

You could ask on turbo124.com as they occasionally come up.
http://www.turbo124.com/forum/viewtopic ... ze+pistons

There was talk on there of converting small block Chevy pistons and rods which would be dirt cheap but I don't think much came of it.

Don't forget to budget in reboring the engine to the next size up. Sadly, it might be cheaper to sell off the blocks just buy a more modern engine.

Try Middle Barton Garage
www.middlebartongarage.com