Morris Minor Owners Club

Hi, ive had to replace both upper pivot arm as the thread was not in good shape. ive got the old pins out the armstrong shock however the question is do the new ones have to be pressed back in as ive bolted it up and tightened but there is a 4mm gap between the large washer, do i need a press to get them right back in to the shock arm?

cheers

I'm amzed you got them off the dampesr in the first place - i have NEVER been able to shift them. But - I am bemused - because these arms don't have any 'thread' - so not understanding what the problem is!

ah does he mean the upper pivot bolt that goes through the damper arm

yep thats the one aupickup the ones thats tapered to fit into the arm, not the actual arm itself on the damper

cheers

You say - 'replace both upper pivot arm' - I foolishly assumed that was what you had done !
If it's only the pin - then just tighten it as best you can - and check again after a day's running.

thanks, seems like ive been a fool and put the wrong nut on and not the castle nut that suppose to be on there for the split pin... ill sort it out tommorow, thanks a lot!