Page 1 of 1
Re Tightening Torques
Posted: Sun Nov 01, 2009 2:41 pm
by mstevens
Hi could any one tell me to what torque I tighten the front hub assembly nut to. Thanks
Posted: Sun Nov 01, 2009 2:56 pm
by PSL184
I don't think there is a specific torque. Just tighten it up to take out any play and so that you can get the split pin in. It's OK to go tighter to get the pin to line up as it's not a taper bearing.
Posted: Sun Nov 01, 2009 3:00 pm
by aupickup
i think its about 45
Posted: Sun Nov 01, 2009 3:26 pm
by bmcecosse
No torque specified in the Manual -just pull them up tight and pop the split pin in! Remember LH thread on the Left side of the car.
Posted: Sun Nov 01, 2009 3:59 pm
by Mogwai
35 - 40 lb,ft in the factory workshop manual
Posted: Sun Nov 01, 2009 4:16 pm
by bmcecosse
What page ??
Posted: Sun Nov 01, 2009 4:20 pm
by Mogwai
General data page 10 (16 on the pdf)
Posted: Sun Nov 01, 2009 4:22 pm
by bmcecosse
Blimey - so it is! I looked right past that. Well done.