Morris Minor Owners Club

Posted: **Sat Sep 12, 2009 4:55 am**

Hi, I was wondering if the 4 bumper attaching points would be adequate support to put the whole car ('61 2 door) on a rotisserie?
I would take the engine and transmission out first, seats and gas tank are already out, but would prefer to leave the rear axle ass'y in.
Need to replace a lot of the floor panels and most of the centre cross member.
TIA, Ken

Posted: **Sat Sep 12, 2009 9:26 am**

I suppose it depends on how solid the car is where the mounts are attached. So check the boot floor and inner wings.

Posted: **Sat Sep 12, 2009 10:02 am**

Hi

This is simelar to the one Im using for the traveller.

As long as your sure the bumper mounts are solid then it will be fine.

Posted: **Sat Sep 12, 2009 10:23 am**

Doors are heavy -I would take them off first.

Posted: **Thu Sep 17, 2009 9:55 pm**

bumper mounts are fine so long they are solid.

Morris Minor Owners Club

Will the bumper anchors support the car on a rotisserie?

Will the bumper anchors support the car on a rotisserie?