Morris Minor Owners Club

Posted: **Wed Aug 19, 2009 10:15 pm**

I've dismantled a quarterlight, removing the glass and rubber insert. When it's reassembled what holds the glass firmly in place?

Posted: **Wed Aug 19, 2009 10:16 pm**

The very tight fit of the rubber and the frame ! I understand they are very difficult to re-assemble!

Posted: **Wed Aug 19, 2009 10:18 pm**

You answered that nearly before I posted the question!!!!

Posted: **Wed Aug 19, 2009 10:53 pm**

Until I got hold of a pair of new old stock quarter lights I was going to stick the glass into the frames with a black neutral cure silicone rubber. I dont think the seals are available.

Posted: **Thu Aug 20, 2009 9:32 pm**

Fortunately I have a decent seal, but I should imagine 'suspending' the glass in a silicone bed would be an alternative. It would be easier to assemble, certainly worth bearing in mind if the glass is not held firm.

Posted: **Thu Aug 20, 2009 9:44 pm**

they are available i got a new set from esm.

Posted: **Fri Aug 21, 2009 6:34 pm**

are teh esm ones the correct profile

Posted: **Fri Aug 21, 2009 7:16 pm**

not tryed them yet