Page 1 of 1
accelerater pedal
Posted: Thu Aug 13, 2009 8:46 pm
by mmjosh
how do you set the accelerater right on a split screen i taken the manifold of and put it back on now cant set it right if you do it to much it becomes stiff if you do it less its loose can anyone explain how i can get it just right.
cheers Josh
Posted: Thu Aug 13, 2009 9:51 pm
by mike.perry
Check that there is no damage or frayed wires on the inner cable. Run a smear of grease along the inner cable before sliding it into the outer casing.
Make sure that the end of the cable is located in the end of the accelerator pedal and the end of the outer casing is tight in the locating holes at the bulkhead and carb end. Pass the inner cable through the hole in the clamp bolt and pull it tight. As you tighten the nut allow a little slack on the inner cable.
Check that the butterfly is fully opened with the accelerator fully down, and closed with it fully up. There is no difference in the set up on a Series II or M1000.