Page 1 of 1
Clutch shaft help required please! A big belated thanks
Posted: Tue Jul 28, 2009 9:05 pm
by Neilhultum
Hi folks, finally managed to get on with rebuilding my 1959 minor saloon and unfortunately after a 5 year gap since i stripped it all down i cannot for the life of me find the nut/ washers or whatever that should be on the end of the the pedal shaft which emerges through the outer edge of the chassis, nor can i remember or find diagrams that clearly show what should be there.
if anybody can help with any info on this it would be greatly appreciated as although i originally photographed evedrything as it came apart in the meantime i had a hard drive failure and lost the lot!
many thanks to anybody who even reads this post even if they can't help.
Posted: Tue Jul 28, 2009 9:42 pm
by mike.perry
See P EE.3 of workshop manal for diagram. If you haven't got a copy I will scan it over.
Posted: Tue Jul 28, 2009 9:57 pm
by Neilhultum
thanks Mike, will have a look for that tommorrow but i couldn't spot the details when i looked the other day, thanks for the tip i'll let you know how i get on.
much appreciated
Neil
Posted: Tue Jul 28, 2009 10:08 pm
by 8009STEVE
This might help.<br>
<br>
Posted: Tue Jul 28, 2009 10:14 pm
by mike.perry
That's a better diagram than the one in the manual
Posted: Tue Jul 28, 2009 11:03 pm
by rayofleamington
should just be a castellated nut + washer and split pin on the outer edge of chassis leg.
spacer tube goes next to the brake pedal on the rod inside the leg.
The picture is very good, but probably less good if you don't know what goes where!
Posted: Wed Jul 29, 2009 8:55 am
by mike.perry
Ref Diagram. What are 24, 25 & 26 and why are they different to 5 & 29?
Posted: Wed Jul 29, 2009 9:49 am
by 8009STEVE
Here is the list that goes with the oher page.<br>
<br>
Posted: Wed Jul 29, 2009 3:55 pm
by rayofleamington
Ref Diagram. What are 24, 25 & 26 and why are they different to 5 & 29?
5 is the assembly of 24,25,26.
27 and 28 are rubbers that go on the pedal (mine usually have neither of them
)
Posted: Tue Aug 04, 2009 2:20 pm
by Pikey
Isnt 24,25 and 26 for a left hand drive mechanism and 5 is the clutch mechanism for a right hand drive car?
The pedal part on 24 has to come off the actuating arm to get the pedal through the toe board.
Steve
Re: Clutch shaft help required please!
Posted: Mon Mar 22, 2010 8:45 pm
by Neilhultum
Sorry for the very long time in responding to all your very kind replies to this post but i haven't been able to access the forum since my last post on this thread and couldn't seem to be able to contact the administrators at the time to sort it out, however yesterday i managed to e-mail them and Jon Rocke has kindly replied and sorted it out for me.
all your replies have been most helpful and are greatly appreciated especially the diagram and that part of the job is now sorted so many thanks to you all.
Neil.
