Morris Minor Owners Club

ive just bought the new window seals for my quarter lights but what is the piece called that the actual window bit slides into? It's all perished and hard so the glass doesn't slide in properly (doesn't close properly either) , thanks in advance

The rubber insert often perishes and pushes the glass out of the quarter light frame. The catches also tend to break off, especially the driver's side. I don't know if the rubber is available separately. It is usually easier to buy a 2nd hand quarterlight

Cut up an old bike inner tube - its only thin rubber....

lol thanks i'll try that , now where are the kids bikes!!

Set it in nuetral cure black silicone rubber. This is how I stuck my drivers door window - worked a treat!

Old inner tubes are always worth keeping for all sorts of car related jobs ;-)

http://morrisminorspares.co.uk/shop/pro ... a51b3e0c27
this is what i baught from esm place 2 pound per side

Should it not be this http://morrisminorspares.co.uk/shop/pro ... a51b3e0c27

that is the bit that goes around the quater light. the bit i put on goes around the glass then into the metal quaterlight

hotrodder13 wrote:that is the bit that goes around the quater light. the bit i put on goes around the glass then into the metal quaterlight

Thats the exact bit i need !! Thanks very much Joanne

no problem. ive baught all new seals for my door tops cause i baught stainless steel ones for my 2door and every rubber had perished

Thanks for all the reply's , iv'e just ordered them , special thanks to hotrodder13 , i'd never have found them without you at last i'll be able to close the things!!