Page 1 of 1
Inlet manifold
Posted: Fri Jan 23, 2009 7:29 am
by Declan_Burns
I have bought this inlet manifold to do some experimenting with a HIF 38 carb. What do I need to connect the hose from the brake servo? Is there an adaptor available or do I have to make up something? What thread is used? Any help appreciated.
Declan<br>
<br>
Posted: Fri Jan 23, 2009 1:04 pm
by alainmoran
Brake servo?
Posted: Fri Jan 23, 2009 1:11 pm
by charlie_morris_minor
It looks like an MG Metro manifold, from what i remember there is a "banjo" that will allow you to connect up to your brake servo. I would have thought the banjo would be shared across the entire metro range so it might be worth looking in a scrap yard.
Inlet manifold
Posted: Fri Jan 23, 2009 2:21 pm
by Declan_Burns
Yes, at least I bought it as a metro manifold.
I found the following on the minispares website and I think it might fit directly instead of trying to source a banjo:
There was also a thread on the minifinity website saying the thread is 5/8" UNF but I'm not sure.
Declan
http://www.minispares.com/Product.aspx? ... 20C-AHT770...
Posted: Fri Jan 23, 2009 3:48 pm
by bmcecosse
Yes - pretty sure it is 5/8 UNF. Just use a stub connector - or get the banjo.
Inlet manifold
Posted: Fri Jan 23, 2009 5:56 pm
by Declan_Burns
Thanks BMC.