Page 1 of 1
Rear Lamp base -what size is the stud?
Posted: Sat Dec 20, 2008 6:39 pm
by jollyroger
Does anyone know what size the stud is that holds the rear lamp base body to the wing?
The old ones are corroded and I can't see them on any of the suppliers websites. I was going to try and buy a length of studding - any suggestions welcome.
Posted: Sat Dec 20, 2008 6:58 pm
by PSL184
I don't know if they changed at different years but what year is your car - It may be important?
Posted: Sat Dec 20, 2008 7:33 pm
by jollyroger
It is a 1969 2 dr saloon. The bases are all the same after 1962 I think!
Posted: Sat Dec 20, 2008 8:18 pm
by rayofleamington
I can't remember off the top of my head but 2ba or 4ba
Posted: Sun Dec 21, 2008 12:53 am
by PSL184
Yes, 2ba - The change of base came in 64 - Not sure if early ones are the same though... I'll check tomorrow if its dry out.
Posted: Sun Dec 21, 2008 9:28 am
by jollyroger
Thanks guys.
I have on old bit of stud and found some 2BA nuts and tried them and it is indeed 2BA. I will order a length of studding.
Thanks again.