Page 1 of 1
2 door interior saftey latch
Posted: Sun Aug 17, 2008 3:21 pm
by aupickup
how do i remove the interior passenger side saftey latch
thanks

Posted: Mon Aug 18, 2008 4:18 pm
by paulk
please anyone? I'm stick in the same boat, can't strip the lock out till I get the catch off.
Posted: Mon Aug 18, 2008 4:43 pm
by alex_holden
Do you mean the little alloy lock lever? IIRC there's a spring pin on the latch body that you have to pull out.
Posted: Mon Aug 18, 2008 6:14 pm
by aupickup
thats the latch
no spring pin on the door lock or on my spare ome

Posted: Mon Aug 18, 2008 6:20 pm
by jaekl
If you are talking about a 2 door, you must reach up inside and pull that wire clip out. It's close to the inner panel and pulls down.
Posted: Mon Aug 18, 2008 7:38 pm
by aupickup
its a late 2 door
there is no clip, nor on my spare handle either
the only clip is on the vertical bar that goes up and down for the latch action
Posted: Mon Aug 18, 2008 10:08 pm
by MGFmad
Mine was the same, the manual states that there is a spring clip but it was wasn't there! There seems to be some sort of locating pin on the end of the latch, as I was waggling it about, it came out, or perhaps my spring was missing!
Posted: Mon Aug 18, 2008 11:11 pm
by aupickup
thank you

Posted: Mon Aug 18, 2008 11:21 pm
by jonathon
Dennis, do not pull out any wire ,clip or other fitting.
With the door cars removed take a fine flat screw driver and feel for a recess in the body of the latch. Its difficult to see so feel is best. There is a spring loaded plunger that needs to be pressed into the latches body, this done the latch will simply release.
The plunger itself is probably ony 2-3mm in diameter so difficult for us 'oldies ' to even see it, let alone contort our bodies, to be in a position to do so.

Posted: Tue Aug 19, 2008 9:10 am
by alex_holden
My 1963 Trav has a spring clip. Perhaps they changed it later.
Posted: Tue Aug 19, 2008 7:05 pm
by aupickup
thank you jonathon

Posted: Tue Aug 19, 2008 10:47 pm
by MGFmad
jonathon wrote:Dennis, do not pull out any wire ,clip or other fitting.
With the door cars removed take a fine flat screw driver and feel for a recess in the body of the latch. Its difficult to see so feel is best. There is a spring loaded plunger that needs to be pressed into the latches body, this done the latch will simply release.
The plunger itself is probably ony 2-3mm in diameter so difficult for us 'oldies ' to even see it, let alone contort our bodies, to be in a position to do so.

Thinking about it again, thats probably what I did (by accident!) and the lever came out.