Page 1 of 1
How to lower front end of morris 1000?
Posted: Thu Aug 07, 2008 10:55 pm
by puchmaxikid
Okay so i want to lower the front of my morris but 1 spline. but not sure how to do this, can you help?
so if stupid question.
thanks
Posted: Thu Aug 07, 2008 11:08 pm
by bigginger
Well yes, but think long and hard on it - tou'll be crashing into the bump stops and tie plate a lot more. Procedure is to remove the front suspension arm and king pin/drum/hub assembly (or at least free it all from the rear arm) the knock the rear arm back off the splines and put it back only one spline diffferent - careful marking needed to be sure you get it right. Then put it all back together. I'm sure others will advise on the cutting down of bump stops etc