Hi Guys,
This is probably really obvious, but I can't work it out! I'm having to replace the headlamp bucket on my '54 series 2. The headlamps are connected with a round bakalite connector which is too big to go through the hole on the back of the bucket. Getting the old one out was easy, I just enlarged the rust hole till it went through. I guess I have to take the connector off to put the new bucket in then reconnect it after, but I can't see how to take the connector off. Please help, I don't want to break it!
HEADLAMP CONNECTOR
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
alex_holden
- Minor Legend
- Posts: 3798
- Joined: Tue Jul 25, 2006 9:46 am
- Location: Burnley
- MMOC Member: No
I would disconnect the wires inside the engine bay and remove the whole headlight loom, then feed them through small end first.
Alex Holden - http://www.alexholden.net/
If it doesn't work, you're not hitting it with a big enough hammer.