Page 1 of 1
Eyebolt thread size?
Posted: Mon Jun 30, 2008 10:14 am
by JimK
Hi all,
what's the external diameter of the eyebolt thread? I'm going to move the bolt outboard slightly and I need to know what size washer to get.
Ta...
Posted: Mon Jun 30, 2008 11:37 am
by Spag
'Spose it's a question I should have asked, before just blasting a couple of 'clearance' holes in some squares of 3mm plate with a stepped cone cutter...
Posted: Mon Jun 30, 2008 8:26 pm
by HarryMango
Hi Jim
It's 9/16" you want.
Rog
Posted: Mon Jun 30, 2008 10:19 pm
by JimK
Ta, much obliged.
Posted: Mon Jun 30, 2008 10:49 pm
by paulk
I have some 16mm Stainless washers if any use Jim. but that must be closer to 5/8th
Posted: Mon Jun 30, 2008 10:55 pm
by JimK
paulk wrote:I have some 16mm Stainless washers if any use Jim. but that must be closer to 5/8th
Yeah, might be a bit big. It'll be pennies to get some the right size.