Page 1 of 1
fiat clutch question...
Posted: Sun May 25, 2008 6:50 pm
by callyspoy
dad question here...
he bought a fiat gearbox, converted to minor bellhousing(im sure you all saw it on ebay!) problem is, he doesnt know what clutch will work as the 1st motion spigot shaft has 21 splines and he cant find one that is the same...any one know much about the fiat 'box's? it is presumed to be mirafiori...
cheers
*Callum* and dad!
Posted: Sun May 25, 2008 8:08 pm
by Mogwai
this QH website is good
http://www9.qha.com/uk/technical/qhcatalogues.htm
click on "Q PID online" gives part no's & cross refrences them plus dimensions etc. I found it useful when converting to a ford clutch
Posted: Sun May 25, 2008 10:29 pm
by bmcecosse
Can the seller of the box not advise what plate to use ?
hi
Posted: Mon May 26, 2008 9:11 am
by neiltomlinson
hi pm sent
you asked about 5 speed box fiat yes it looks like fiat mirafiori like the gearboxs i have i have cluch plates etc a will try them later & see what fits let you now or give me a call 077seven4585five51 neil
Posted: Mon May 26, 2008 8:25 pm
by Innovator
You can use Ford clutch plates on the Fiat. The splines are the same as some Fords.
My Minor uses a Ford cover and plate (though I did need to put new dowels and tapped holes to bolt on the clutch cover)
Sorry but I cant remember the exact spline dims (21 on 25mm ???)
hi
Posted: Fri May 30, 2008 9:49 am
by neiltomlinson
hi up date just tryed fitting ford cluch the one used on 5 speed to mogey fly wheel no good far to big on the splines pity you can not turn the fiat cluch down on a lathe then it will fit fine neil